gregchrysler
-
Posts
306 -
Joined
-
Last visited
Content Type
Forums
Gallery
Events
Posts posted by gregchrysler
-
-
wood is still being done-- white ash is thicker than the original so slow deterioration has angle iron backing also -paint taken down to bare metal- tell me what I can do to improve it specifically - will take more pictures of wood after being done --not asking $160,000 also
-
tried hemmings and ebay at $79,000 reduced it to pay mortgage to 21,900 thanks Lebowski it really is a steal I can's understand why no one is bidding
-
use jumper cables from battery to starter --negative on casing of starter positive to starter bolt should turn starter-- bang starter with hammer solenoid may be stuck
- 1
-
-
-
-
-
check ignition wiring also when positive battery cable hits starter post with positive it should turn starter
-
leave original starter wires on and add jumper cables
-
run a jumper cable to the positive side of the starter and the other cable to either the negative battery side or a good ground then u will know if it s the wiring
-
-
check voltage regulator and cca on battery they go bad after 3 years and check grounds and wire gauges and connections on starter
-
-
-
-
-
-
thanks everybody got it back in still no reverse sprag?????
-
all doors open and close perfectly - I m not trying to get top dollar There is a lot of room money wise to perfect the car
-
wood is still being done
-
I had the same problem Brought the starter back 5 times and finally he discovered that the alignment of the bolts on the starter (positive and negative) 2 bolts on the bottom of the starter were not aligned internally in the starter-- instead of being 180 degrees transverse internally they were not making contact fully enough to start the gear push to the flywheel So align bolts internally and externally I tried everything also
-
keiser there is one for sale $95,000 on e bay I am asking 1/2 of that another one for $160,000 on e bay This could be an investment it wont take too much work to finish but I need to sell it I know it is not perfect but the price is mechanics are almost done Thanks for you help anyways. wood is being sanded that was urethaned
-
Matt everyone can't have concurs cars like you I am redoing the wood to pure white ash tranny is being gone thru It's not perfect but maybe someone could finish it up and make a lot of money and then maybe they could afford to buy one of your concurs cars at pebble beach
-
Woodie 1/2 price out of money Chrysler Royal 1949
in Automobiles and Parts - Buy/Sell
Posted
also new 16 gauge floor boards and new tranny tunnel