Guest Rick Evans Posted October 17, 2013 Share Posted October 17, 2013 Does this type hub require the KR Wilson hub puller. It doesn't have the groove that I was expecting to find. Link to comment Share on other sites More sharing options...
Guest Rick Evans Posted October 17, 2013 Share Posted October 17, 2013 I also located a vintage ford hub puller for $20. Would this work? Link to comment Share on other sites More sharing options...
peecher Posted October 17, 2013 Share Posted October 17, 2013 (edited) You have pictured a front hub. It requires no puller. Remove the cap (pry off) unscrew the nut, outer bearing and the hub can be removed. The old puller will work on the rear hubs which do have the "groove". Edited October 17, 2013 by peecher (see edit history) Link to comment Share on other sites More sharing options...
Guest Rick Evans Posted October 17, 2013 Share Posted October 17, 2013 this board is awesome, thanks for the help Link to comment Share on other sites More sharing options...
tom nelson Posted October 18, 2013 Share Posted October 18, 2013 that front hub is threaded,do not pry it off,it has right hand thread on both sides. Link to comment Share on other sites More sharing options...
peecher Posted October 19, 2013 Share Posted October 19, 2013 Oops, you are so right. Those "hex" caps were threaded and the "round" ones were the pressed on type. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now