Guest dwscott Posted February 21, 2012 Share Posted February 21, 2012 What current fluid can be used and where do you put it in? Link to comment Share on other sites More sharing options...
RickBrinker Posted February 21, 2012 Share Posted February 21, 2012 Use straight 10 wt non detergent motor oil,for the torque converter there is a cover on the passenger side of the hump almost under the dash open the cover and turn engine over until you see a pipe plug remove the plug and fill until the oil starts to run out.The Trans fills from under the car fill until oil come out of the top fill hole. Link to comment Share on other sites More sharing options...
Guest dwscott Posted February 22, 2012 Share Posted February 22, 2012 Thanks for the info. Torque converter plug should be easy to find but not sure about trans fill plug. Anymore advice on tranny plug,ie, left/right side, etc. Link to comment Share on other sites More sharing options...
RickBrinker Posted February 22, 2012 Share Posted February 22, 2012 Left side middle of trans Link to comment Share on other sites More sharing options...
Guest dwscott Posted February 22, 2012 Share Posted February 22, 2012 Thanks again! Link to comment Share on other sites More sharing options...
Rusty_OToole Posted February 25, 2012 Share Posted February 25, 2012 One more tip. Before you take the plug out of the Fluid Drive unit, stuff a rag around the hole. This makes it impossible to drop the plug down into the bellhousing. Hate to tell you how I figured this out Ha ha. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now