pistoncollector Posted February 15, 2010 Share Posted February 15, 2010 I need a water pump impeller that has a 4" OD, a 3/4"ID and an overall thickness of 13/16"+/-. It can have 5 to 8 vanes, but 6 is preferred. I would like it to be made of brass or bronze but cast iron is acceptable. Does anyone have an impeller close to these dimensions or a source for impellers?Thanks ........ Paul Link to comment Share on other sites More sharing options...
Larry Schramm Posted February 15, 2010 Share Posted February 15, 2010 What kind of vehicle are you working on? Do you have any pix? Link to comment Share on other sites More sharing options...
pistoncollector Posted February 15, 2010 Author Share Posted February 15, 2010 The vehicle is a 1910 Chalmers Detroit. The impeller does not need to be exactly like the one in these photos, as I mentioned at the start of this thread.Thanks ....... Paul Link to comment Share on other sites More sharing options...
pistoncollector Posted February 15, 2010 Author Share Posted February 15, 2010 Link to comment Share on other sites More sharing options...
pistoncollector Posted February 15, 2010 Author Share Posted February 15, 2010 Larry,I tried twice to post some photos of the impeller. The photos show up when I type the message but don't come up in the new thread. Let me try to figure out what is going on. Maybe I will have to send them directly to your email address.Paul Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now