EJM3 Posted January 2 Share Posted January 2 I removed the 4 nuts and washers that go through the floor pan. Tried to pull up seat but would not budge. Not much info out there in regards to removal of the seat. Any advice would be appreciated. Link to comment Share on other sites More sharing options...
1957Birdman Posted January 3 Share Posted January 3 Here goes: after removing the 4 nuts, pull the seat upwards and tilt it forward. Remove the retainer pin on the motor drive and disconnect the wires on the motor drive. At that point the seat should be able to be removed. If the seat won't move than be sure that you have removed the correct 4 nuts from the studs. The seat rails should not have been glued to the floor pan, but if the seat has never been removed it could be somewhat rusted in place. Let us know what you find. Lew Bachman 1957 Thunderbird Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now