Jump to content

Series 5 Intake Manifold machining drawings


21raceabout
 Share

Recommended Posts

Looking for a set of machining drawings for the Series 5 intake manifold (aluminum casting with flange provision for cross-over pipe heat/exhaust down pipe).  I need to finish a repro raw casting that was made some 10-15yrs ago by the same owner who had the repro engine block cast for his car.  Thinking that machining drawings must have been made up (or the original factory drawings) to facilitate finish machining of the repro intake for his car. 

Thanks in advance for any leads.   

 

 

 

 

 

 

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...