MrLiken Posted September 29, 2014 Share Posted September 29, 2014 I have "lost" approx half of the mating surface for my engine water inlet. Does anyone have experience with a good fix for this?Thanks,John Link to comment Share on other sites More sharing options...
MikeC5 Posted September 29, 2014 Share Posted September 29, 2014 No experience with this particular problem but there are people out there who can weld on cast iron. An alternative until you find someone who can weld build it up might be to clean it up with a burr and then apply some high temp RTV silicone liberally and bolt the fitting back on. Since there's so little pressure it should hold. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now