!935 Series 40 Clutch

[kevzpix]

Hi

I wonder if anyone can provide me with clutch set-up measurements, to enable correct re-assembly of my clutch. My W/shop manual gives the maximum tolerance for the vertical alignment of the pressure plate relating to the flywheel, but apparently I need two critical measurements : (1) the distance from rear-facing side of the clutch-release-plate, to the rear-facing side of the pressure-plate; and, (2) the distance from the rear-facing side of the clutch-release-plate, to the rear of the cutch-plate. :confused: .

I appreciate any information, which anyone has.

Kevin O'Connor