30Marquette

I am located in Northeast Ohio

I have a 1930 Buick Marquette. Iy the glass in the driver side door broke.I would like to replace it, However I don't know how to remove it or have any instructions on how to remove it.Also would need to know how to remove the crank and door handle to remove the interior panel. I don't want to ruin anything because parts are very hard to come by. Thanks, 30Marquette

Thank You Mark

Looking a schematic of this carburetor. So I know what each screws does what so that I can get the proper adjustments. Any help would be greatly appreciated.

Looking for a carburator rebuild kit for a marvel !0-175 carburator and for 10-748 fuel bowl

Well finally got my car going however after driving for a couple of miles it stalls out. It will start back up but when it does I may be able to go a couple hundred feet or another couple miles. When it does stall its like its not getting any gas. I just had the fuel tank cleaned and sealed it to eliminate the rust. The fuel pump is in good working order. Had the points and condenser replaced. Just not sure if the carburator is adjusted correctly or if there is something else I am over looking.

Well finally got my car going however after driving for a couple of miles it stalls out. It will start back up but when it does I may be able to go a couple hundred feet or another couple miles. When it does stall its like its not getting any gas. I just had the fuel tank cleaned and sealed it to eliminate the rust. The fuel pump is in good working order. Had the points and condenser replaced. Just not sure if the carburator is adjusted correctly or if there is something else I am over looking.

Mark, I have done a little more research and found that the Model is a VM-3. Not sure what measurement you are looking for but its 2-15/16" from center to center of the mounting holes.

Yes its a Marvel all i have is the casting numbers on the carburetor 10-175 and on the fuel bowl 10-748 . I will have to measure the the size of the mounting flange.

I am looking for a carburetor for a 1930 Buick Marquette

I am looking for a fuel bowl for a Marvel Carburator the casting number on the Carburator is 10-175 the casting number for the fuel bowl is 10-748.