ctc72961
Members-
Posts
21 -
Joined
-
Last visited
Content Type
Forums
Gallery
Events
Everything posted by ctc72961
-
Can anyone make a recommendation on where i can purchase new seat cover(upholstery) for my '69 Buick Electra Convertible ? Thank you ctc72961
-
Im unable to find any information in the owners manual or shop manual on how and where the spare tire jack is located in the trunk. I do not see any hold-down clips or brackets. I presume it its suppose to be stored behind the spare tire..... just it just sit there with no tie down ? photos of location and method of tie down would be greatly appreciated ctc72961
-
1952 Chrysler Windsor Deluxe $8,500.00 Hard Top 67,0000 Original miles 6cylinder Flat Head Solid Original Car with no Rust Equipped with a 3 speed manual transmission with overdrive (shift between gears without clutch) Highlander This car is a barn find from Lancaster county Pa. Recent work; Brakes, all new wheel cylinders, shoes, hoses and rebuilt master cylinder Front wheel seal Front suspension. new kings pins and front and rear shocks Carburetor rebuilt including new filter Fuel Pump rebuilt Rear inner an outer wheel seal replaced Transmission completely overhauled including overdrive unit and wiring New clutch and pressure plate and throw-out bearing and clutch fork boot Clutch transfer link rebuilt....and much more Call 609-462-7412 to make an appointment more photos on request
-
1969 Buick LaSabre engine and trans, 350cid with 74,000 miles, 4 barrel and 400 turbo trans... Runs great... this is for engine and trans only $1250.00 please call for more info Located in South Jersey region 609-462-7412 $1,250
-
Im working on a 1931 Buick 60 Series and need to replace/repair the Torque tube ball seal that is leaking very badly.... no seal kit is available from vendors ….can anyone offer any solutions or remedies or perhaps was able to retrofit later kits to work.....thank you for your help !!
-
We are working on a 1927 Dodge Fast Four in our shop and are in need of some parts Intake manifold vacuum tank horn can anyone help ? thank you
-
This is the same hose that I have on the car now however it needs to be replaced. I see a lot of replacements hoses on the market that are listed for a '53 Cadillac but do not have the restrictor. My questions is does anyone have experience installing the replacement hose without the restrictor they are available from many of the Cadillac dealers
-
I'm trying to replace the Power steering hoses on my '53 Cadillac 60S. I took the hoses to my local hydraulic hose shop for fabrication and they told me that there is a restrictor built into the pressure hose. Unfortunately they don't have the restrictor so they cant make the hoses. I've seen some of these hose for sale on the internet but they don't appear to have the restrictor.....Is this necessary to have ??...... does anyone have any experience with replacing these hoses both pressure and return hoses and do you know a supplier? Thanks Carl
-
I recently purchased a 1969 Buick Electra Convertible thathas the optional stereo unit (not the tape player unit) mounted under the dash. I had the radio and stereo amp repaired howeverthe stereo amp was disconnect so I am unsure of how to reconnect the radio andstereo amp together. I recall seeing awiring diagram once that should the proper wiring. Does anyone know to wire these units togethercorrectly? I also have a what appears tobe a fader dial mounted in the lower access panel of the dash that must controlfrt & rear speaker any help begreatly appreciated, thanks All, Carl BCA 17588<o:p></o:p>
-
John, thanks for the reply.. I have drum brakes all the way around the car. I'm going to be removing the rims tomorrow so that I can mount a new set of tires on my existing rims until such time that I can locate a good set of rally rims. I was hoping to have located a nice set of Rally rims so that I can only do this once....but no luck I will look to see if the "ring" is still in place on my existing rims I am assuming the register ring will provide me with information that will help me identify the correct rim, for example "Bolt Pattern" Im under the impression I need 5 on 5 pattern for my Electra
-
<o:p> </o:p> Currently my 1969 Buick Electra Convertible has the stock 15’ rims and hubcaps. I would like to install the Buick Rally Rims. Ive been told that the 15” 5-5 bolt rims from later model Buicks from the 80’s & 90’s will work on my ’69 Buick Electra... <o:p> </o:p> can anyone with experience in this matter verify this information or can anyone tell me specific year(s) and Models from other Buicks that might work, Thank you in advance
-
Rusty, this is the best advise with regard to starting an old engine I have ever read. I recently bought a '37 Buick which has been sitting for some time and I was searching for the same advise. You laid it out step-by-step. Excellent work!!
-
1937 Buick Special Front Fenders
ctc72961 replied to ctc72961's topic in Automobiles and Parts - Buy/Sell
suchan, thank you for the help. I am aware of dave and have purcahsed from him before. I was hoping to find something local, but I'll keep him in mind, best, carl -
Hello everyone I’m new to this AACA forum website but have heard a lot about it. I’m in search of two front fenders for a 1937 Buick Special. I live in the North East (<?xml:namespace prefix = st1 ns = "urn:schemas-microsoft-com:office:smarttags" /><st1:State w:st="on"><st1:place w:st="on">New Jersey</st1:place></st1:State>) and if anyone has any leads on parts or even a parts car I would be interested in knowing about it, best regards to everyone, carl