Jay Wolf Posted November 7, 2005 Share Posted November 7, 2005 Original 6 volt AM radio in a 1955 Ford Thunderbird.I replaced all tubes and have had the radio in out 3 times.When you start the car the radio will not work the light comes on but no noise, no static, no nothing. If you leave it on and hit a bump it will come on and play fine.Once on it has never quit on any additional bumps. If you turn the car off for less that 5 hours or so it will come on when the car starts, but it is set overnight or so the radio won?t play till you hit a bump.Anyone has a similar problem? Any suggestions on what to look for? Link to comment Share on other sites More sharing options...
Guest Randy Berger Posted November 7, 2005 Share Posted November 7, 2005 Offhand, it sounds like a vibrator problem. Aren't there any radio techs near you where you could have the vibrator tested? Second thought is to install a speed bump just outside the garage. Sorry, couldn't resist) Link to comment Share on other sites More sharing options...
Guest Posted November 7, 2005 Share Posted November 7, 2005 99% of all tube radio failers is the vibrator that buzzes, and chopsthe dc current in ac currnet by flipping back and forth inside a tincan in the radio.The vibrator has double points that stick together for not beingused.If you pop the back of the radio off, pull out the vibrator, a tincan with four plug on the bottom, uncrimp the can, and open it up,you will find the double flapper points.Just sand them down a little, and you will be back in radio heven. Link to comment Share on other sites More sharing options...
Guest imported_JPIndusi Posted November 7, 2005 Share Posted November 7, 2005 Check all the external wiring for a loose connector. On some models the light is wired separately. Could be a loose tube or poor connection of the tube pins in the socket. The vibrator is also a suspect here. Substitute a known good one or best of all, send for a solid state replacement from one of the servicessuch as Classic Auto Radio Service in Florida, 800-880-1409.If you replace the vibrator you should replace the buffer capacitors (used to be called condensers). These (sometimes only one) are the only high voltage capacitors in the radio chassis, usually marked 1200 to 1600 volts. If they are bad they can kill a vibrator in short order.Joe, AACA, BCA Link to comment Share on other sites More sharing options...
Guest strait8 Posted November 8, 2005 Share Posted November 8, 2005 [color:\\"purple\\"] Just a light tap on the vibrator with the bottom off the radio will confirm that the vibrator is defective if the radio then starts playing, but it could be a loose socket which also could be confirmed by gently wiggling each tube and also tap them with the handle of a small screwdriver to locate an intermitent tube. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now