How to Cross reference Starter Ring Gears?

[laheyth]

I have a 1913 Overland 69T that has been converted into a speedster, I wish to install a ring gear on the flywheel and a electric start, but browsing the internet, I cannot seem to land on a site that lists starter gears by diameter. I need one that is about 18 inch I.D.(P.D.~19 inch)

Any one seen such a website?

Then I need to match a starter that will turn CCW as seen from the front of the car(starter bendix to the rear) start the CW turning engine.

Alternatively, does anyone make replica Grey and Davis starters?

[Guest cben09]

Gee are you having start problems,,,I had a 13 a few years ago and it was a good starter,,,,,Lots easier than a Ford,,,,If it will idle nicely,,it'll probably start good too,,,,Pay attention to the idle,,,Good luck ,,Ben