BoL

Hi, I have buoght a oilfilter to my ST 300 automatic transmission, but it will not fit. I tried to get the new filter in place but the thing that happend was that I broke the new filter when I tried to push it in to the hole in the gearbox. When I messaured the diameter of the "pipe" was it 1 mm (1/25 inch) bigger than the "pipe" on the old filter. Is there anyone that know if there any manufactur of filter that fits better or what filter i shall buy to not get the same problem. I live in Sweden so I'm not sure what manufactuers I can get but come with proposal, I might can get something that will fits better, in other case I have to try to modify a filter so it fits better.

Hi, What oil should I use in the automatic transmission in my 1967 Buick Lesabre? the owners manual recomend "AQ-ATF" oilfollowed by a number and the surffix A, for example (AQ-ATF-XXXX-A) what oil is this? Is it possible to use Texaco Texamatic 7045E Dexron III oil? Hope you will understand my english, I'm from Sweden so my english are not the best.

<div class="ubbcode-block"><div class="ubbcode-header">Quote:</div><div class="ubbcode-body">Way not tray www.buicksinsweden.se or www2.hemsida.net/buickowners/ </div></div> Thanks fore the links, I have tried the www.buicksinsweden.se with out no luck, shall try the other one to se if someone can help med with my problem. /Bo

I have been out in my garage and checked on the wipers. I try to pull the flat lever on the underside of the wiper down to the body with a screwdriver and then I got that small "clip" part loose but it don't change any thing I can just pull the wiper a small bit (about 1/32 inches) on the axle then it stuck and will not go any further. What can I do wrong or what can be wrong? I see that the whole axle are moving outwards when I try to pull the wiper so I'm a little bit affraid to pull hard in the wiper. /Bo

Hi Thanks for answer, I must go out in my garage and see more, I thought I have find the leveler you talking about. I will loose the left wiper beacuse its not in the right position on the axel, when it runs it will go so long that it up on the goes off the windsheild (I don't know the english word for the part of the body that are on the side of the windsheild and between the windows on the doors) but the wiper goes up on the body.

Hi I hope you could understand what I mean, I'm from sweden so I'm not so good on english. I got a 1967 Buick Lesabre and I would like to get the windsheld wipers of the car but I can't loose them. The part of the "wiper arm" that connected to the spline axle seems to be in one aluminium pice not like on other cars where you got a nut under a cover. There is a something on the under side of the aluminium part witch I think are going be pressed when you should loose the wiper from the axel. I have use rust remover on the pices and I can also move the wiper a wery smal distance on the axel so my problem is how the the locking system betwen the axel and the wiper is made. I don't want to use to much violence when I shall take away the wipers so I break something. Hope someone can help med with this /Bo