68GS

Thanks to all for the info. I have purchased several manuals from ebay... waiting for them to arrive! Then, all I need is the time and the money... should only be a minor issue!

Thanks for the info... I am currently the bidder on the assembly manual because I can use all the help I can get to restore the car! Thanks again!

When I purchased my 68 GS400 convertible, I did not verify 'numbers matching'. What all do I need to verify to determine that mine is a 'numbers matching' car? I cannot find any build sheets. The following is what I think I need to match? Then, how do I know that the numbers on the engine, tranny, and rear axle came with that car and not a 68 Skylark? I am planning to do a body-off restoration at the end of this year. - dashboard VIN (found) - cowl tag (found) - engine block numbers (cannot find) - transmittion stamp (found) - rear axle tag or stamp (cannot find) Do I need all these for a 'numbers matching'? What else do I need for a 'numbers matching'? Thank-you in advance!

Thanks for the info, but when I try to view the selection for Buick, the site says it is in error??? I am looking to repaint to another 68 Buick color.

Does anyone know where I can find an exterior paint chart with paint numbers for a 1968 Buick... GS400 convertible. Thanks!

Thanks for the info!

I have a 68 GS400 Conv. with an automatic. I am looking for a source for inexpensive headers. So far, everything has been $500 to $900. Anyone have a good source? Thanks, Gil - Mpls.

I have a 68 GS400 Conv. with an automatic. I am looking for a source for inexpensive headers. So far, everything has been $500 to $900. Anyone have a good source? Thanks, Gil - Mpls.

I have a 68 GS400 Conv. I am looking for inexpensive headers. Prices I have found range from $500 to $900. Anyone have a good source?

Thanks for the info!

I have a 68 GS400 conv... original 400 - slightly built, original tranny, original rear end. I was considering swapping for a posi. Current ratio is 3.08. I get about 13mpg. Any idea on the ratio I can use and still get over 10mpg? Any help would be greatly appreciated. Thanks, Gil - Mpls.

Where are you located? Do you have a ball-price? Is the vehicle complete? engine, transmittion, axle, interior? I have a 68 GS 400... could use some parts. I am in Minnesota. Gil 763-434-7900

I have a 68 GS 400 Conv. I definetely need a top... with glass back window! Where are you??? How much for top? How much for all? Do you have other parts? Black buckets? Any sheet metal? Gil Mpls, MN

Thank-you very much!

I am looking for a frame and/or rolling chassis for a 68 GS400 convertible. Any help... Mpls, MN.