[motor/trans mounts]

I am restoring a 1962 Chrysler Newport Conv. with 361CID and auto trans (A727 aluminum) and need engine and transmission mounts. Know where I can get some?????

[Bias tire wheels]

I have heard that if a radial tire is put on a bias tire wheel, the flexing of the radial tire will break the bias tire wheel. Is this true??? If so, where could I find radial wheels for my 1948 Plymouth Convertable.

Gary Frey

[Bias tire wheels]

I have heard that if a radial tire is put on a bias tire wheel, the flexing of the radial tire will break the bias tire wheel. Is this true??? If so, where can I get radial wheels for my 1948 Chrysler NewYorker?

Gary Frey

[61 Crown Imperial Trans. Gasket]

Does anyone know where to get the A727 Cast Iron Transmission gasket and filter?

Gary Frey WPC # 11732 [color:"red"]

[1962 Chrysler 300 almost "H"]

I have a 1962 Chrysler 300, 2-dr sedan that has a 300H (413 engine, 2-4bbl carb-in line), 300H (120 MPH Speedo), and 300H hubcaps. Is this car unusual and how many made.

Gary <img src="http://forums.aaca.org/images/graemlins/confused.gif" alt="" />

[1924 Dodge Phaeton-Special Series]

I an doing a frame off restoration and wondered how many Special Series vehicles were made.

Gary

[33 Chrysler C0 Rear axle outer seals]

I am finishing my restoration and I need rear axle outer seals. Roberts Motors does not have them. Any ideas where I can get two??

928-632-7355

[24 Dodge Distributor]

I am restoring a 1924 Dodge Brothers Screen Side Delivery. The gear on the end of the distributor and on the accessory drive shaft from the

water pump are both worn. The timing is jumping all over the place. The distributor is fine, I just need the gears.

Does anyone know where to get gears????

Gary Frey

gfreynpo@cableone.net

[48 Chrysler NewYorker oil filter canister]

My streight 8 engine oil filter canister has a nut on the top of the oil filter canister cover

that is tightened down after a new filter is installed. As this nut is tightened down,

it forces a copper or brass washer down over the top stem of the oil filter cap to

seal the top of the cap. No matter what I do, oil leaks out of the bottom of the

nut around the copper/brass washer.

Anyone know how to stop the oil leaks???

Gary Frey

e-mail: gfreynpo@cableone.net

[6V light bulbs]

Where can I find 6 Volt bulbs for my 34 DeSoto Airflow??????

Or does everyone change their electrical system to 12 Volts?

Thanks, Gary Frey

E-mail:gfreynpo@mindspring.com

[Electroluminescent Power Module]

I have a 61 Crown Imperial and the power transistor for the 200V power module,

that makes the instrument pannel work, has failed. The number on the transistor

is 934, but there must be a newer replacement number. Does anyone know of

a new number so I can fix this module.

Thanks,

Gary Frey (gfreynpo@mindspring.com)