Jump to content

gfreynpo

Members
  • Posts

    11
  • Joined

  • Last visited

    Never

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

gfreynpo's Achievements

  • Collaborator

Recent Badges

0

Reputation

  1. I am restoring a 1962 Chrysler Newport Conv. with 361CID and auto trans (A727 aluminum) and need engine and transmission mounts. Know where I can get some?????
  2. I have heard that if a radial tire is put on a bias tire wheel, the flexing of the radial tire will break the bias tire wheel. Is this true??? If so, where could I find radial wheels for my 1948 Plymouth Convertable. Gary Frey
  3. I have heard that if a radial tire is put on a bias tire wheel, the flexing of the radial tire will break the bias tire wheel. Is this true??? If so, where can I get radial wheels for my 1948 Chrysler NewYorker? Gary Frey
  4. Does anyone know where to get the A727 Cast Iron Transmission gasket and filter? Gary Frey WPC # 11732 [color:"red"]
  5. I have a 1962 Chrysler 300, 2-dr sedan that has a 300H (413 engine, 2-4bbl carb-in line), 300H (120 MPH Speedo), and 300H hubcaps. Is this car unusual and how many made. Gary <img src="http://forums.aaca.org/images/graemlins/confused.gif" alt="" />
  6. I an doing a frame off restoration and wondered how many Special Series vehicles were made. Gary
  7. I am finishing my restoration and I need rear axle outer seals. Roberts Motors does not have them. Any ideas where I can get two?? 928-632-7355
  8. I am restoring a 1924 Dodge Brothers Screen Side Delivery. The gear on the end of the distributor and on the accessory drive shaft from the water pump are both worn. The timing is jumping all over the place. The distributor is fine, I just need the gears. Does anyone know where to get gears???? Gary Frey gfreynpo@cableone.net
  9. My streight 8 engine oil filter canister has a nut on the top of the oil filter canister cover that is tightened down after a new filter is installed. As this nut is tightened down, it forces a copper or brass washer down over the top stem of the oil filter cap to seal the top of the cap. No matter what I do, oil leaks out of the bottom of the nut around the copper/brass washer. Anyone know how to stop the oil leaks??? Gary Frey e-mail: gfreynpo@cableone.net
  10. Where can I find 6 Volt bulbs for my 34 DeSoto Airflow?????? Or does everyone change their electrical system to 12 Volts? Thanks, Gary Frey E-mail:gfreynpo@mindspring.com
  11. I have a 61 Crown Imperial and the power transistor for the 200V power module, that makes the instrument pannel work, has failed. The number on the transistor is 934, but there must be a newer replacement number. Does anyone know of a new number so I can fix this module. Thanks, Gary Frey (gfreynpo@mindspring.com)
×
×
  • Create New...