Manu

Hi. How are the windshield wiper towers originally attached to the 1936 series 40. I have 2 screws on each tower but i don't see any way to attach them under the dashboard. I think parts are missing. Thanks for any help.

Thanks Neil. It's done 👍 Video Thank you all for your advices. Manu

Thank you for all your suggestions. The picture and the video from Neil helped me a lot to see how the whole thing is set up. I will try to clean the passage today. I will report back to you.🤞

Thanks Neil. How deep is the hole passage?

No😊

Hi guys. Thanks for all the answers and ideas. Yes, of course I drilled a 1/4" hole in the freeze plug and a new thermostat was also installed. When the engine was apart we scraped out the worst of the rust we could see and vacuumed it out. We did this for a long time because there was a lot of rust in the engine. I just don't want to use acid because I'm afraid it will eat the cylinder head gasket. Thermocure is made of a non-toxic and water-based solution that is easy-to-use on automotive cooling systems. It is non-corrosive and non-flammable.

Hi. I rebuilt the thermostat housing and removed the bypass valve and replaced it with a freez plug. I then let the engine warm up in the stand until it was up to temperature. There is coolant in the cylinder head. But when I open or even remove the petcock on the side of the block, no coolant comes out. I have tried to clean and scrape out the hole mechanically but without success. Perhaps someone has an idea what I can do. I have discovered the product evaporust thermocure, but unfortunately it is not available in Luxembourg. Here is a video of the running engine. engine run

Hi guys. I have another problem. The engine is running again after reassembly, but no cooling water is circulating in the engine. I deliberately did not install a thermostat. I am therefore all the more surprised that there is no coolant in the engine. Can someone please give me some advice. Thank you very much.

Thanks guys. You are great.🙏

Hi guys. Sorry i have an other question. Take a look at my radiator. Do you think, the cap is the correct one? The cap has no pressure spring. It's a Harrison raditor and the overfill tube ( i don't know the correct name) is in the middle on the top. Thanks.

Hi. Happy new year. What's the water temp sensor thread size in the engine. I have to plug it because I want run the engine in a stand. I can measuring the temp using a laser. Thanks.

You are right Bloo. Thanks. My clicking finger was faster than my brain 🙂 I ordered this one now. 1/4 NPT

OK thanks guys. I ordered a new one. Petcock