Carla Larsen

Mark, I would like to speak to you. Please email a contact number. creekside@methow.com

We are looking for some of the same parts. If you find any levers or parts please let us know. Carla creekside@methow.com

My lever controls for the throttle and spark advance are broken and cracked. Does anyone have these parts? Can they be repaired? We have pictures to send if we have your email. Can't figure out how to post them here. Thanks, Carla

Coley, We can not figure out how to send pictures through this site, therfore please provide your email address. Thanks, Carla creekside@methow.com

My levers on the throttle and the advance located on steering wheel is a cast/pot metal and it needs to be repaired. Any suggestions as to whom could repair these cast parts. This for a 1924 Buick. This would include casting a new thumb lever and welding it to the ring under the horn button. Please help! Thanks, Carla 509-996-2664 creekside@methow.com

Need at least two 32x4 tires or 32x4.5 for 1924 buick. Any used/serviceable tire? Thanks, Carla 509-996-2664

1) I need a pair of headlight lens for my 1924 -45 touring Buick. They are a Guide Tilt Ray that measures 9" overall with 7 3/4" of actual lens. 2) Any parts out there for the light / ignition switchs? I need the plate that is black has the positions stenciled on it which covers the switch it self, the glass and levers. This is the not the round one but the one that is more oval. I purchased a good switch from Ebay that has the correct number of terminals but its round, therefore I need the other cover plate/bezel 3) Need the advance lever on the steering wheel which has the the thumb knob/lever under the horn button 4) Need two estrusion (sp?) plates that are kidney shaped for the door latches on the inside of the door. These hold the covering of the door material where the latch comes through. 5) Need two door knobs that screw on to the top of the latch on the inside of the door. They are just an extention of the latch and were nickle plated. About 1" + long and round. 6) Need four scuff valance plates, that have the word BUICK cast as part of the plate. 7) Need the handle bar on the back of the front seat/the attachment brackets. I believe this was used to drap a blanket over. 8) Need 7 lug/clamps for the wheels that have BUICK on them.

If it is all there and not a rust bucket, it is well worth the $700.00

I have been offered a 6cyl engine to purchase along with a car. I believe it is about a 1925/26. The casting # on the L/H side next to the Buick logo is 189040-4. Above this is 0197. The serial number on the tag is 1949050. The nuts on the valve cover are of the acorn type. It has a down draft intake, which I believe to be not of the same year. What year is the engine? When did Buick use a down draft intake that would fit this engine? The engine is nearly complete, in dry storage, any thoughts as to value? Thanks, Carla