[HUDSON CRANK HOLE COVERS]

WTB Crank hole covers for 1930, 34 AND 35 HUDSONS.  RVB9549@AOL.COM

[WHAT FOUR CYLINDER ENGINE IS THIS? CAN ANYONE HELP? SEE CHASSIS PHOTOS, TOO]

I am not sure. Paid a lot to get it to PA from Wisconsin, thinking it was (as advertised) an Essex, to put in my Hudson Museum.

The radiator itself may not be correct to the shell. Look long and carefully. If I plan to cut it and scrap it, I will let you know. Use my real email, rvb9549@aol.com

PS Will be at HET National. What year rad do you need? Shell too?

[WHAT FOUR CYLINDER ENGINE IS THIS? CAN ANYONE HELP? SEE CHASSIS PHOTOS, TOO]

Thanks. Starter etc were stolen while on trailer at motel overnight bringing it back. Has OHV with single bolt in valve cover if that helps. Found what looks like chevy bowtie embossed on right frame rail with #848532 on one line and "17" below that. Thanks. Robert Blake rvb9549@aol.com

[WHAT FOUR CYLINDER ENGINE IS THIS? CAN ANYONE HELP? SEE CHASSIS PHOTOS, TOO]

Please help me identify this engine/chassis. Thanks Robert Blake <rvb9549@aol.com>

[distributor for 1922 maxwell]

I have a 1922 Maxwell with what I believe to be a 1929 Plymouth four cylinder distributor in it, presumably because the original went bad.

The one in the car is DelcoRemy 635W. I believe the original was DelcoRemy 369 A/B/C. The car had been running well with the 635W till recently.

The driven gear on the distributor shaft is worn and I plan to replace it.

Can someone tell me how to access the drive gear inside the engine to replace it at the same time? Other ideas on this distributor swap?

Any ideas or help is most appreciated. Direct email RVB9549@AOL.COM

If there is anyone truly familiar with these willing to come to Allentown PA area to help get it set up, please let me know and we will come to an agreement.

Thanks, Robert Blake

[willys-knight dealer Clark & Dowling]

Hello! Can anyone help me identify where a W-K dealer called Clark and Dowling was located back in the 20s? Please email me directly. Robert Blake

rvb9549@aol.com Thanks.

[1918 h6 ignition point set needed]

I hadn't but I will tomorrow. I thought this might be a true oddity! Thanks again. RB

[Terraplane Front Brake Disc Conversions]

Fat Man Fabrication makes a Mustang II front suspension kit with DB for this app.

[1918 h6 ignition point set needed]

Hi everyone! I am looking for a points set for my 1918 Hudson. Can anyone supply them??? Thanks. Robert Blake 516-658-7295

[1938 terraplane wants parts]

Anyone with a 38 coupe parts car? Anyone who has resto-rodded a 38 terraplane out there? Thanks. RVB

[wanted to buy]

Looking for strong running 48-52 Hudson EIGHT cylinder engine. Will buy entire vehicle for right engine. NYC area.

[Terraplane Floorpans]

Take a look on ebay. There is someone remanufacturing floor panels and trunk floors for later 30s Hudson which would likely work for you with some trimming.