35Dictator Posted October 6, 2007 Share Posted October 6, 2007 Hi all.I am having a tough time getting my transmission back in after taking it out to clean the clutch and clutch plate.We used an alignment tool with the correct splines to fit the clutch plate but the end that fitted into the flywheel was loose.We had two to choose from and used the bigger one but still was loose. Would this be enough slop to cause the problem?Just by guessing the tool was half inch and the flywheel hole 9/16 to 5/8th's.Would adding tape to the tool work to take up the slop?Another thing is the transmission shaft seems to bind into the throw-out bearing, is there any trick to just even getting the bearing on the shaft? We have the bell housing on so maybe that's the prob. and we just need to align. the shaft/clutch plate first and then put the bell housing on?Thanks a bunch as were getting a bit frustrated. Link to comment Share on other sites More sharing options...
35Dictator Posted October 11, 2007 Author Share Posted October 11, 2007 DONE!!!!!!!!!!!!! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now