lincolnV12 0 Posted April 11, 2007 I recently acquired a large pile of V12 parts and among the parts was a transmission. The previous owner couldn?t remember if the transmission belonged to a Zephyr or not.The number stamped into the top of the bell housing above an inspection cover is HTT4643* (star) I believe and the number cast into the tail housing is 86H -1514-9.From these numbers, is it possible to ID this tranny?Thanks Share this post Link to post Share on other sites
Rolf 0 Posted April 11, 2007 Sounds like you may have a '38-'39 Zephyr transmission, the # on the case is usually the VIN #, but the T's in your # are bogus. You can easily tell if it is one of those valuable units if the opening for the cover is on the right hand side rather than on the more common left hand side, and if there is a very odd shaped shift lever. What year car are you working on?? Share this post Link to post Share on other sites
lincolnV12 0 Posted April 11, 2007 I don't have a car yet. I was looking for a V8 flathead for my 38 Ford pickup when I found this pile of V12 engines and parts. The owner was moving to Florida and just wanted everything gone so I bought the whole pile of parts. About three pickup loads of stuff. I have 6 v12 engines, and more shocks, heads, cranks, cams, water pumps and misc junk than I know what to do with.Perhaps the T's are really 1's or 7's. I'll have to go look again and get a picture. I'll also check the open and there is an odd shaped shift lever.Thanks Share this post Link to post Share on other sites
Guest imported_V12Bill Posted April 12, 2007 The 38 to 39 transmissions have value to the owner of a 38 or 39 car. Some hot rodders like them because the shift is on the right side of the transmission and they can get more room in the car for themselves. The gears are just the plain old Ford gears though and not the coveted 40 to 48 gears. Share this post Link to post Share on other sites
peecher 6 Posted April 12, 2007 If those "T's" are actually "1's" then the serial number would indicate a mid year 1941. Does the transmission have an Overdrive on it? The "86H-1514-9" is probably really 86H-4514-9 and is the basic p/n for 1/2 of the ball cap that secures the torque tube to the transmission. Share this post Link to post Share on other sites
lincolnV12 0 Posted April 12, 2007 As they say, a picture is worth a thousand words so let me see if I can figure out how to attach a picture or at least a link. http://i174.photobucket.com/albums/w106/brians38/Car4-12001.jpg Share this post Link to post Share on other sites
lincolnV12 0 Posted April 12, 2007 OK that picture came out a little bigger than I thought it would but does that look like a Zephyr transmission?Thanks for your help! Share this post Link to post Share on other sites
Rolf 0 Posted April 12, 2007 Yes, that is a picture of probally a 1941 LZ non OD transmission, as Peecher so correctly surmized, the next thing is to open it up and see if you have a good set of the Z gears Bill mentioned, the cluster should have 26 teeth on the front gear, but it could have 25-28 or 29 teeth there too Share this post Link to post Share on other sites