One touch entry system control box

[carbuff]

I cannot find the one touch entry system control box on my 1989 Reatta. I have looked in the trunk behind the driver's side shelf speaker and it is not there. I want to program my key fab. Any suggestions on where else to look?

[Jim]

The module for the keyless entry is located behind the panel on the drivers side in the rear area but you do not have to get to the module to program the remotes. There will be a green single wire connector near the ABS computer on the drivers side in the trunk behind the trim panel. You ground the connector in the following manor---------.

Before starting this procedure, BOTH transmitters must be present. Failure

to use both transmitters will render the missing transmitter inoperative.

If the customer uses only one transmitter on the vehicle, use this

transmitter as transmitter 1 and 2.

The entire reprogramming sequence must be completed within 30 seconds of

grounding the connector. If the procedure is not completed, remove the

ground at the connector and restart the procedure from step 1

1. Ignition "ON"

2. Ground green single wire connector ( located near the ABS module in the

trunk.

3. Wait for the door locks to lock and unlock ( should take 2 seconds)

4. Press the "unlock" button on the first transmitter twice ( pauses for

one second between presses)

5. Wait for door locks to lock and unlock ( should take 2 seconds)

6. Press the "unlock" button on the second transmitter twice ( pause for

one second between presses)

7. Wait for door locks to lock and unlock ( should take 2 seconds)

8. Remove ground from green conector.