Jump to content

48 V-12, installing distributor


Recommended Posts

The tab at the back of the distributor shaft and the cam slot are both slightly off-center. If you try to install it wrong, you will know because the distributor mounting bolts will not line up right. Hope this helps.

Link to post
Share on other sites

Cece is absolutely correct, but I learned a even easier fool proof way to do it, and that is to put the distributor up to the plate with the 3 cap screws that hold it on, but those bolts finger tight, then reach in the openings where the caps go on and gently turn the rotor while putting a little pressure backwards, in less thn a full rev, the slot and tang will align, and your distributor is installed properly, hope that helps, Rolf

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...