Leif Holmberg Posted August 10, 2005 Share Posted August 10, 2005 Need advice how to install Conecting Rods on the Crankshaft on my 1925 std..I am not sure about what is "front"and what is rear on the Rods.Thanks Leif in Sweden.E-mail leif.holmberg@telia.com Link to comment Share on other sites More sharing options...
Fred Rawling Posted September 13, 2005 Share Posted September 13, 2005 Pistons must be replaced on rods so that when assembled in the engine, the offset of the piston pin will be toward the camshaft and the pointed projections on the cap and in the channel will point to the rear of the engine Link to comment Share on other sites More sharing options...
Leif Holmberg Posted September 14, 2005 Author Share Posted September 14, 2005 Thanks Fred.I removed the crankcase(florpan?) on my other Buick std.1925 and found out how to turn the rods (as you wrote).Thanks Leif in Sweden. Link to comment Share on other sites More sharing options...
Patrick W. Brooks Posted March 19, 2006 Share Posted March 19, 2006 Good Morning Leif: I have many 1925 Standard parts. Included is complete intake and exhaust manifold assembly, water pump, wheel bearings and races,starter/generator and much more. What do you need? Please contact me at Brooker50158@hotmail.com Thanks, Patrick W. Brooks Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now