smaltzie Posted February 7, 2004 Share Posted February 7, 2004 can someone tell me how to get the rear window chrome off a 56 buick special? Heard that it hold in the rear window. I only want the chrome off to sand and patch. Also have a rear 56 bumper (century)for dual exhaust, would like to trade for a 56 special bumper. Link to comment Share on other sites More sharing options...
Judd Posted February 7, 2004 Share Posted February 7, 2004 Smaltzie There are bolts under the rear deck that hold the bottom piece on, the top piece is pressed into the rubber. I'm talking about the two pieces at the bottom of the back glass. I have a Special single exhaust bumper but the Century bumper should fit a Special.Judd Link to comment Share on other sites More sharing options...
Guest herkamer Posted February 7, 2004 Share Posted February 7, 2004 how much for the 56 bumper? condition? e-mail herkamer16@hotmail.com Link to comment Share on other sites More sharing options...
smaltzie Posted February 8, 2004 Author Share Posted February 8, 2004 i'll email you some pictures Monday. has some surface rust.Randy Link to comment Share on other sites More sharing options...
smaltzie Posted February 8, 2004 Author Share Posted February 8, 2004 ok i'll look again for the bolts. what about those two side pieces of chrome. And how much for your single exhaust bumper? Randy Link to comment Share on other sites More sharing options...
JohnD1956 Posted February 8, 2004 Share Posted February 8, 2004 My 56 Super 2 door has that wrap around glass. There is a chrome belt that starts over the doors and runs over the trunk. This is pretty wide and it was held on by bolts in side the trunk and there were hidden screws inside the area's over the windows. But I assume you are talking about the narrow strip around the glass. This chrome was a special treat. On the top and bottom, there are spring clips similar to newer 60's cars but the corners had clips that were placed inside the chrome strip, and the clips had bolts attached. The body had holes drilled thru the channel where the window goes and then there were nuts inside the car. I had to take the inside chrome off to get to them.And they were not fun to get back on. Good luck. Link to comment Share on other sites More sharing options...
smaltzie Posted February 9, 2004 Author Share Posted February 9, 2004 i'll look again. but i have only 4 open holes which show no bolts. I have a 4 dr. with a wrap around window. I will take the trime out from aroune the window. Also the sides from the inside. Is it hard to change the window seal, i know i have a bad leak, it is a little rusted out in one spot.ThanksRandy Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now