v12lincoln Posted May 20 Share Posted May 20 I had a brake problem and ended up mushrooming the end of my axle. I have a new/used one to replace it, need to know a safe way to get it out. Already have hubs off. Link to comment Share on other sites More sharing options...
19tom40 Posted May 26 Share Posted May 26 You will need a spring spreader to remove the rear end from the spring and then you can disassemble the rear end to remove the axle. You will need a gasket set for the rear end and the set should include the different thickness gaskets to adjust free play and bearing pre-load. As you disassemble the housing keep track of which gasket position and replace the gaskets with the same thickness on each side. This Service manual describes the procedure. https://www.ebay.com/itm/276188704819?fits=Year%3A1948|Model%3ADeluxe|Make%3AFord&itmmeta=01HYV2CS11D8487ETSQNZZZN4C&hash=item404e213033:g:TicAAOSwC3hlYOmH Link to comment Share on other sites More sharing options...
v12lincoln Posted May 27 Author Share Posted May 27 Thanks, got it done with 2 floor jacks 2 sets of jack stands a C clamp and ratchet strap. Now just need a shim for the axle taper as hub slides on and off easy and presses against backing plate. Sacramento vintage ford sells them but closed today Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now