Hub Pullers for 1920-21 Stutz

[PMac]

Looking to check over the brakes on my 1920 Stutz H Series. The parts booklet lists a pair of hub pullers in the tools section. I assume these are screw on cup type pullers, one each for the left and right hubs? Does anyone have a set of hub pullers for this car (Buffalo No.5 Wires)? Perhaps someone has a set of originals or has made some and could post some pictures or provide details? Appreciate any help/suggestions with this.

Thanks,

Peter

 

 

[Layden B]

This is the Houk #5 wire wheel hub puller from Wire Wheel Corp. of America.

Left hand thread on one end and right on the other of course!

With the square shaft and very short taper of the Stutz axle design you probably do not need a puller.

Loosen the axle nut and if the hub is not loose, leave a small gap between the nut and the hub, put the cotter pin back in and go for a short drive.

Chances are it will be loose when you get back!

 

[PMac]

Thanks Layden.

Peter

[STuTZ693]

Hi Peter,

I think any good machine shop could make you a puller.

One side of the bone has right hand threads and the other Left hand.

I have one here and could make you a sketch/drawing.

Dan

PS Hope you can join us in Dublin, Oho in June for the Grand STuTZ.

[PMac]

Thanks Dan, appreciate the suggestion.

Peter