Jump to content

Early Gas Tank


oldford
 Share

Recommended Posts

I have an early gas tank that I believe is for a large car. The tank is 35 1/2" wide and 12" in diameter with filler on one end and a port for a float gauge on the other end. Vent is in the back about in the middle and the outlet fitting is dead center on the very bottom...

 

Any ideas?

 

Frank

IMG_4153.JPG

IMG_4154.JPG

Link to comment
Share on other sites

OK, Mike here are the measurements:

 

Clutch diameter (small edge of cone): 13 7/8"

Clutch diameter (wide edge of cone): 14 3//4"

Hub diameter at bolt flange: 5 1/2"

Hub length: 5 3/4"

 

I said it was Marmon, only because it came with a boat load of Marmon stuff. Really, I'm not sure...

 

IMG_4158.JPG

IMG_4159.JPG

IMG_4160.JPG

Edited by oldford (see edit history)
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...