Jump to content

64 Buick Skylark exhaust


papafarms

Recommended Posts

Hey everyone, hope someone can help me or give me some suggestions, my exhaust pipe leaving the manifolds has pin holes in it, it has the 300 engine in it so i don't think there are many nos pipes or reproductions being done for this car.  Will heat exhaust tape work on this or is it too close to the exhaust manifolds for this to work.  The tape advertised as up to 850 degrees, but a comment was not to use it that close to the manifolds.  So unless someone has a spare pipe to fit, any suggestions or advice.  As always thanks for the replies, Bob

Link to comment
Share on other sites

I bought a complete stainless steel system for my '64 Skylark from Waldron's. I'm very pleased with it. If your car is a keeper, that's what I recommend. If you don't want to go for the full Monty, check with them to see if they'll supply only the pipe you need.

Link to comment
Share on other sites

A good "Old Fashioned" Muffler shop should be able to fabricate the pipe and install it - generally while you wait.

We've got a good one here, and they stay busy, as you would expect.

  • Thanks 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...