BrushGuy Posted March 13, 2021 Share Posted March 13, 2021 Wondering if anyone might have a Liberty step plate they could loan or share detailed dimensions and photos of. I have the wild hair that I would like to try to fabricate a pattern for casting using a 3D printer. Any help would be greatly appreciated. Link to comment Share on other sites More sharing options...
Simon Anderson Posted March 30, 2021 Share Posted March 30, 2021 This may help you Link to comment Share on other sites More sharing options...
BrushGuy Posted March 30, 2021 Author Share Posted March 30, 2021 Thanks Simon.....if you could send the length and width dimensions for the rectangle with the bolt holes, I believe I can figure it out and make a pattern. Much appreciated......Have a great day. John Link to comment Share on other sites More sharing options...
Ben Popadak Posted March 30, 2021 Share Posted March 30, 2021 If the photo above is of an original Brush Liberty step plate then you should not need to cast up the step part at least. I've been looking for that style of step plate off and on for some time now. The step plate with a 5" diameter pad is used on the 1902 Rambler and one step plate on an original frame I have is rotted off at the step. I bought one similar off ebay years ago only to find out it was 4 1/4" diameter if I remember right. Too small for my needs but I finally got a 5" one a month ago. Keep looking on ebay for the 4 1/4" step. Be patient and use buggy step or carriage step to whittle down the pile. The down comer should be able to be reproduced by a good welder/ fabricator, should you get good dimensions. Good luck. Link to comment Share on other sites More sharing options...
Simon Anderson Posted March 30, 2021 Share Posted March 30, 2021 Link to comment Share on other sites More sharing options...
BrushGuy Posted April 1, 2021 Author Share Posted April 1, 2021 Thanks for the added dimensions....and info. Link to comment Share on other sites More sharing options...
caddyshack Posted April 8, 2021 Share Posted April 8, 2021 Any photos out there of an original Liberty step plate? I have only seen one, and that was at Homer Edmiston's auction many years ago. That step plate had a Brush logo, very similar to early Cadillac step plates. Link to comment Share on other sites More sharing options...
BrushGuy Posted April 11, 2021 Author Share Posted April 11, 2021 I have never seen that one..... Link to comment Share on other sites More sharing options...
Simon Anderson Posted April 11, 2021 Share Posted April 11, 2021 Are my steps liberty steps in the pictures? I was told they where Brush Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now