Jump to content

Recommended Posts

4 hours ago, cokeman said:

Need 6 way drivers seat transmission for my 1983 Buick riviera contact at ssimpson6@charter.net

 

Do you really need the transmission? The most common failure mode in these power seats is the plastic coupler between the motor and the transmission. The problem is that the D-shaped hole that fits over the shaft rounds out inside. New ones are available everywhere, since these were used on just about every GM power seat in the 1980s. I've had to replace these in several of my cars.

 

159447344_1980_86_el_camino_gmc_caballer

Link to post
Share on other sites
  • 4 weeks later...

Joes right. If you hear the motor turning thats good. Stick your head under the seat and hit the switch. You'll see the motor spinning and where that coupling is supposed to be.

Link to post
Share on other sites
17 hours ago, deaddds said:

Joes right. If you hear the motor turning thats good. Stick your head under the seat and hit the switch. You'll see the motor spinning and where that coupling is supposed to be.

 

I'll note that in both times this happened on my cars, the coupler was in place and looked just fine. The problem was that the small D-shaped hole in the coupler that fits over the motor shaft had rounded out, so the shaft just spun inside the coupler. You can't see this until you take it apart.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...