Jump to content

Recommended Posts

Chryslers of this era usually have babbitted big end bearings on the conrods and the main bearings are probably thick removeable brass shells that are babbitted.

Unfortunately, even if you are lucky enough to find a set of new old stock main bearings, you will still have to line bore them to suit your crankshaft. 

 I think you will have no option, but to find an engineering shop that can re babitt all the bearings for you. Brace yourself for a motor rebuild and the expense that comes with it.

 

Link to post
Share on other sites

I required babbit bearings for the 7 mains and 6 connecting rods for my Dodge DA-6. I feel fortunate to have a local craftsman here in Sacramento CA.  It is quite a process and was able to help him.

Very expensive . Cost could vary between $2000 and $4000 for just the Babbit bearings alone.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...