Jump to content

48 Packard ignition switch


52 Dodge Ed
 Share

Recommended Posts

I determined I have a faulty ignition switch.  I went to remove it to inspect/repair/replace and the first thing I see is two small holes on opposite sides of the bezel.  Probably for set screws?  I tried to look in there but with bifocals this is not working!  Does anyone know what fastener should be in there?  Flat screw? Allen head? Other? I can try everything I have, but hate wasting that much time while in awkward position with bad knees.  

Link to comment
Share on other sites

I found the answer, using my secret weapon:  sheer determination!  There was a post on my Packard club site from 6 years ago.  Turns out the small holes are for a spanner to turn the bezel.  Sounds much easier than set screws.  Time will tell.  

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...