Jump to content

Lipe pressure plate

Recommended Posts

I have rebuilt my Lipe pressure plate and had to make some new springs. Now putting it all back together I am not sure how to set the 6 bolts that hold it all together. Theses are the studs that go through the 6 fingers that the throw-out bearing presses on. there must be some type of procedure to get this adjustment correct.

long winters here in Maine and it just gets us in Trouble!!!


Link to post
Share on other sites

Attached are two pictures of what I have and need.

I need the distance in the picture with the scale. It looks like somewhere around 3/4 to 7/8. but could be anything.

I need the distance from the finger to the bottom of the crossbar. or the finger to the top surface. both are the same thing.

clutch 1.jpg

clutch 2.jpg

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...