P2 dome light

[vette-kid 18]

Anyone know how to get this open to access the bulb and wire?

[Scott Bonesteel 98]

The outside chrome ring and the lens comes out as a unit.  The switch stays put with the body of the light.  The outside ring has 4 lightly spring loaded tabs that stick straight up into the body of the light.  There are no screws or clips involved.  I will shoot a couple of pictures to you shortly, showing one disassembled.  To remove, I would just try to slip my fingers under the outside of the chrome lip on the long sides of the lip and simply pull down, perhaps with a slight wiggle.  Be careful as the glass lens will come with the chrome lip.  The body will be screwed into the roof bows and the switch, as well as the switch lever, will stay attached.

[Scott Bonesteel 98]

Couple of photos of the dome light disassembled so you can see the tabs that hold it together.

[vette-kid 18]

Thanks.  That's kind of what I figured but didn't want to pull to hard until I knew for sure.  It was a little stubborn but came out fine.