cquisuila Posted January 7, 2021 Share Posted January 7, 2021 where are the seats belts fasteners on my Buick riviera 1966 please ? I have the belts but they don’t connect to the chassis😁 Link to comment Share on other sites More sharing options...
54vicky Posted January 12, 2021 Share Posted January 12, 2021 some had plastic covers where they bolt through floor.some even had a flip up cover built into cover.they can be hard to pull back.the bolt may be a 56 torx.good luck removing the bolts either way as they are tight Link to comment Share on other sites More sharing options...
joe_padavano Posted January 12, 2021 Share Posted January 12, 2021 Front and rear belts were factory installed on your 1966. There will be factory hard points in the form of threaded nut blocks visible on the underside of the floor pan. Likely the carpet was replaced and the belts were not reinstalled. Link to comment Share on other sites More sharing options...
cquisuila Posted January 21, 2021 Author Share Posted January 21, 2021 iT seems that, on my car, the bolts have disappeared as the picture ? 🙃 Link to comment Share on other sites More sharing options...
joe_padavano Posted January 21, 2021 Share Posted January 21, 2021 10 minutes ago, cquisuila said: iT seems that, on my car, the bolts have disappeared as the picture ? 🙃 Likely the belts and fasteners were lost when a previous owner replaced the carpet. Link to comment Share on other sites More sharing options...
cquisuila Posted January 21, 2021 Author Share Posted January 21, 2021 the belts are here it just missing the bolts on the front i have to find the good bolts??!! for my 1966 riviera Link to comment Share on other sites More sharing options...
joe_padavano Posted January 21, 2021 Share Posted January 21, 2021 OK, type GM seat belt bolts into Google... Of course, you'll need to figure out if your car uses the 7/16 or 1/2 fasteners Link to comment Share on other sites More sharing options...
cquisuila Posted January 22, 2021 Author Share Posted January 22, 2021 (edited) CORRECT bolt as OPGI.COM But it is not notifing the diameter ???😬 Edited January 22, 2021 by cquisuila MODIFY (see edit history) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now