Ketch89Reatta Posted December 26, 2002 Share Posted December 26, 2002 Passenger low beam on my 89 Reatta was dead. Replaced headlight and still no low beam. Hi beam works fine. Is there a positive jumper wire that leads from drivers side to passenger side I should be isolating for continuity? Other suggestions? Link to comment Share on other sites More sharing options...
Guest Gomer Posted December 26, 2002 Share Posted December 26, 2002 my high beam did the same thing found a brokne wire on the drivers side! hope u have the same problem. Link to comment Share on other sites More sharing options...
Barney Eaton Posted December 27, 2002 Share Posted December 27, 2002 There are a couple of possibilities...... first since the high beam works (you only mentioned the low) that would normally eliminate a bad ground.I would almost bet your headlight wires are routed wrong. When that happens, the opening and closing of the lights, flex the wires going into the connector and break the copper..... the insulation may still be holding it in place...pull on the three wires going into the black connector and one will probably pull out. Link to comment Share on other sites More sharing options...
Guest Posted December 27, 2002 Share Posted December 27, 2002 Had exact same problem on driver's side. Sprayed contact cleaner in connector and works fine now. If this easy fix doesn't do it, Barney's advise is next.good luck,curt Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now