Jump to content

1922 Buick Speedometer Cable


Recommended Posts

Yesterday I removed my speedometer cable so I could inspect it and clean it up.  The cable was attached to the left side (Drivers) of the transmission and attached to the inside of the frame by an attachment point with a clip.  The cable housing looked to be in good shape.   The cable ends also appeared to be in good shape and the flat sliding  piece in the end piece at the transmission seemed free moving.  So I went on the take the end pieces off and slide the inside chain out of the cable housing.!cid_e3cb6677-c4f4-47d3-a6a0-442bd13a12a1@namprd10_prod_outlook.thumb.jpg.3f863d90a0a83f5a5a1d0a665b736747.jpg 

!cid_2592d809-357c-464f-a174-e47870538aa5@namprd10_prod_outlook.jpg

!cid_502f91ab-8eb3-4d9b-86a7-d1ac5e09254f@namprd10_prod_outlook.jpg

!cid_31a29d68-431f-4264-bfb1-15eeeac661ad@namprd10_prod_outlook.jpg

Edited by Mark Kikta (see edit history)
  • Like 2
Link to post
Share on other sites

I put the chain in a pan of kerosene to scrub the 100 years of grease off and it came quite clean.  I use a steel rod with spray brake clean to clear hardened grease inside the flex housing then poured kerosene and used the garden hose to spray out the housing also.  I used compressed air to dry out the cable before shoving a bunch of white lithium grease into the housing using my steel rod. Then I attached the chain to a piece of wire that I ran through the housing and I had my wife slowly pull the chain into the housing as I covered it in white lithium grease also. It all went together quite well and I'll spray the housing black and re-install.

!cid_5ea2ed97-357d-4e09-a093-7414d3ffa857@namprd10_prod_outlook.jpg

!cid_028f4246-e47c-411a-af60-d3fc0198ee52@namprd10_prod_outlook.jpg

  • Like 1
Link to post
Share on other sites

I don’t have a good speedometer because the car didn’t have one in the hole.  I have purchased 3 over the last 2 years and hope to turn them into one good one.

Link to post
Share on other sites

Just for record purposes on this forum I took some measurements of each.  
 

The flex housing was 66 inches long.

The chain cable was 63 in long without the special ends

The chain cable was made up of 55 total links.  There were 3 links measuring 1 1/8 in long and 52 links measuring 1 3/8 in long.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...