Jump to content

ISO 5 Inch Diameter Water Pump Impeller


Recommended Posts

56 minutes ago, mikewest said:

Brian , why not make one? Your machinist can spin out the blank and mill the flutes. Its not a horrible job. Id get a block of manganese bronze..


We may end up there yet.  Thx. 

Link to post
Share on other sites

I have these two. The smaller open one is 4",11/16 hole and side holes for a pin,maybe it could be brazed up some. $45 shipping included. The other is enclosed,it is 5" or a hair more. The center hole is about 1/2" and threaded. $75 shipping included. Holler if interested.

IMG_8580.JPG

IMG_8581.JPG

IMG_8582.JPG

Link to post
Share on other sites
1 hour ago, sagefinds said:

I have these two. The smaller open one is 4",11/16 hole and side holes for a pin,maybe it could be brazed up some. $45 shipping included. The other is enclosed,it is 5" or a hair more. The center hole is about 1/2" and threaded. $75 shipping included. Holler if interested.

IMG_8580.JPG

IMG_8581.JPG

IMG_8582.JPG


Thanks

 

Need more vane depth, at least 3/4 inch to fill the housing.  

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...