Jump to content

1919 Buick rear hub removal


Recommended Posts

Posted (edited)

Hi all, to replace a rear wheel bearing in my Buick I obvioulsy must remove the wheel and hub. I made a fast attempt at it earlier buy decided to stop to make sure I was doing the correct thing. The wheel bearing has slight play in it when rocked. The hub cap and nut are removed, the shaft and woodruff key are not binding on the drive flange as they can be tapped in and pulled out slightly, I am assuming the bearing shell is just stuck to the stub, I fitted a bearing splitter to the hub and I can fit a puller to it to pull the hub off from against the shaft, is this ok to do or has anyone experience with a better method. Thanks

Alan

20200521_180327.jpg

Edited by Alan G (see edit history)
Link to post
Share on other sites

Rear hub removal depends on whether the car is a 4 or 6 cylinder model.

If 4 cylinder, then hub must be pulled from  the axle shaft.

If 6 cylinder, then remove the 6 acorn nuts and pull the entire axle shaft and driving flange out by hand - no puller should be necessary.

Then you will see a large nut that has to be removed and the wheel can be pulled and the bearing will be accessible.  Picture below should be close enough for 1919 model.

Kevin

rear hub 6 cyl.jpg

  • Like 4
Link to post
Share on other sites

Thanks Kevin. Yes, it's 6 cylinder.That makes sence now that I have seen the diagram. Thank you very much for that. Appreciate it

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...