meskhov

Tillotson Rebuilder?

Recommended Posts

Can anyone recommend a carburetor rebuilder that does the early 20's Tillotson's that they have had good luck with?

I have a MV-1B in need of rebuilding.

Thanks.

Share this post


Link to post
Share on other sites


Benefits of AACA Membership.

Posted (edited)

If the pot metal is good then they're not bad to do. If the pot metal warped or cracked then it is a problem. Ask Carb King. He is on this site. Dandy Dave! 

Edited by Dandy Dave (see edit history)

Share this post


Link to post
Share on other sites

Dave:

Actually, this is an all bronze carburetor.

I'm trying to find a shop that does the early 20's versions.

Thanks for the reply.

  • Like 1

Share this post


Link to post
Share on other sites

Good Harley mechanic might also be able to help.

Share this post


Link to post
Share on other sites

In the For What Its Worth category:

 

Most of the early bronze carbs, including Tillotson, had pot metal venturii. Virtually all rebuilds of these carbs should include a new venturi to be machined, unless it has already been replaced.

 

As far as Tillotson is concerned; many of the early Tillotsons used a "vane box" with steel vanes that deflected with the air velocity (basically an early variable venturi design) in the air intake. The Tillotson documentation stated these vanes should be tested for fatigue (they would stiffen with the flexing over time), replaced with new as required, and adjusted with a special Tillotson tool (which I have never seen, and I seek out and collect carburetor tools!) I also have never found documentation on the specifications of the steel used for the vanes.

 

I realize quite well that this site promotes originality, to which I generally agree. However, if I owned a car with one of these that I actually wanted to start the engine, rather than look at it; I would certainly NOT try starting it with a Tillotson carburetor.

 

But to answer the OP's question to the best of my knowledge, I am unaware of any professional that will touch one, other than the aftermarket JR series.

 

Jon

Share this post


Link to post
Share on other sites

Taking the above post 1 step further.

 

My records show the MV-1B of the OP to be original to a 1926 Star with a Continental W5 engine. A further check of the records show:

 

(1) In 6 years, Star tried 10 different Tillotson carburetors on the W5 - why?

(2) Checking the Continental records, most of the W5 engines went to Star and Durant, all using Tillotsons, but Oswald used a Continental W5 with a Stromberg SFM-1, part number 127-1, production number F-3673.

 

Jon.

Share this post


Link to post
Share on other sites

Jon:

Thanks for the advice.  I see a lot of these on 20's cars at Hershey so someone is doing them. I'll have to look into a replacement as I see your point about the vanes and the pot metal venturi.

I have seen some Durants with a Marvel-Schebler TSV or X from a Continental F-162 motor used in farm equipment.  I don't know how well the linkage adapts.

I'll post this on the Durant technical site and see if anyone has a carburetor upgrade.

Thanks again.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now