Jump to content

Recommended Posts

If I remember correctly for my 22 6cyl Olson's kit came with cork pieces for front and rear end caps because I remember They were hard to keep in place while installing the pan.

Link to post
Share on other sites

Maybe you are right and there was not one for the rear,  It seems like that could have been the case now that I think some more.  I do remember fitting  the gasket around the rear cap. When you get old you get that CRS syndrome😁

Link to post
Share on other sites

On my 1925 6 cylinder standard, I have 1 photo of the rear pan end and 2 photos of the front.  There is a strip of cork that wraps around the crankshaft area on each end.  The front cork strip is longer than the rear strip.  The book of parts also mentioned 2 small chunks of cork by size for the rear bearing, but these were not in the kit (which was not purchased from Olson).   Be sure to coat both sides of the gasket with sealant.  I am partial to blue hylomar for a gasket sealant.   Hugh   

 

1137221321_IMG_7082rearpangasket.thumb.JPG.b48be7de184b7a5597b7e45260c87d6a.JPG22277097_IMG_7083frontpansidea.thumb.JPG.091f4ec8e7b5376c5c88a884faf2413f.JPG86824418_IMG_7084frontpansideb.thumb.JPG.2c98bfaef8753332596bc886d89cdee7.JPG

 

 

Link to post
Share on other sites

Here is a photo of my rear end cap, and now I remember there was no seal for the rear cap, there was an oil slinger on the crank right behind it to keep oil from going out the rear.

A2371289-C7CD-4283-8378-19870016962D.jpeg

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...