Jim Nelson Posted January 10, 2020 Share Posted January 10, 2020 I am rebuilding my 1935 lower ‘A’ frame but the pivot pin that goes thru the yoke is not good. It’s a 1” diameter pin with cross drilling’s to get grease to the two bronze bearings. Both pins are in need of replacement. Is there a nos pin available ? 1 Link to comment Share on other sites More sharing options...
Jim Nelson Posted January 12, 2020 Author Share Posted January 12, 2020 pont35cpe, I contacted the guys in Ca. Rare Parts. Cherry was very nice. I have found that some King Pin kits (80/90 series) have a diameter of 1.062. I think that can be centerless ground to get to the correct dia. Also, the 38-90 'A' frame in the same position has a 1" dia pin that seems to be identical to the pin on my '1935' yoke. I have cross referenced these pin dia. with my service manuals so this may be good. I have let the guys at Rear parts know what I've found. It should be interesting what they come up with. 1 Link to comment Share on other sites More sharing options...
Jim Nelson Posted February 9, 2020 Author Share Posted February 9, 2020 Rare Parts in California had a great replacement. A better design than the original design.... 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now