How do you remove the clip that holds the end of the sun visor?

[Ronnie]

Not the end that pivots. The clip that holds up the other end.

[DAVES89]

On the coupes there is one screw. There is a "guide pin to help keep it from spinning. Should come right out.

[Ronnie]

My '88 has one screw holding the clip on. A guy sent me and email saying his '90 coupe didn't have a screw and couldn't figure out how to get it off. Could the '90 be a different design on the clip?

[Barney Eaton]

The convertible visor clip has one screw you can see........to get the second screw out you must unfasten the front of the top and move it back enough to get to the screws that hold the black plate at the top of the windshield.

After removing that plate (it goes completely across the top of the windshield) you can get to the screw on the inside that holds the second visor screw.

Helpful hints..........the inside screw is going thru some fairly thin plastic and sometimes pulls thru so you do not need to remove the top plate to remove the visor clip but to reinstall a new visor clip you must take off that top plate.

To help avoild the  inside screw from pulling thru the plastic add a washer to reinforce ....if it has pull thru you must add some sort of washer or the screw will not hold.....the washer (reinforcement) can be metal or plastic but

you need something that is tougher than the thin plastic it is mounted on.

The sketch below gives you an idea

[Ronnie]

Thanks Barney. He said he had a '90 coupe.  Maybe he has a convertible. I emailed him back for clarification.