Cokekid Posted May 17, 2019 Share Posted May 17, 2019 Has anyone ever replaced the brushes in this starter. I removed the armature to clean it up but when I tried to install it back into the case it seems the four brushes get in the way .The need to be withdrawn so the armature can be installed all the way in. Any help would be appreciated. Gerry Link to comment Share on other sites More sharing options...
38ShortopConv. Posted May 17, 2019 Share Posted May 17, 2019 (edited) Pull each brush wire out against the spring tension, peg them, or release the spring so the brushes clear the armature. [commutator] Edited May 17, 2019 by 38ShortopConv. (see edit history) Link to comment Share on other sites More sharing options...
Cokekid Posted May 18, 2019 Author Share Posted May 18, 2019 38ShortopConv. Can you explain what you mean by "peg them" Link to comment Share on other sites More sharing options...
38ShortopConv. Posted May 18, 2019 Share Posted May 18, 2019 (edited) Tie the brushes up out of the way to allow the armature to be reinstalled all the way in. Edited May 18, 2019 by 38ShortopConv. (see edit history) Link to comment Share on other sites More sharing options...
Cokekid Posted May 18, 2019 Author Share Posted May 18, 2019 38ShortopConv. I kind of though that's what it meant. . Thanks Link to comment Share on other sites More sharing options...
19tom40 Posted May 18, 2019 Share Posted May 18, 2019 Pull the springs away from the brushes and then push the brushes away from the commutator until the spring can rest against the side of the brushes. Assemble the starter and then push the brushes against the commutator. The springs will seat on the back of the brushes. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now