Sign in to follow this  
olefre

1948 Chrysler - Lower control arm LH

Recommended Posts

Where are you at olfre?

If the Windsor is the same I have a parts car you can pull one from.

Its probably going to scrap soon.

Located in NW Oregon.

Share this post


Link to post
Share on other sites
Posted (edited)

The 1946-48 8 cylinder  Saratoga, NewYorker and Imperial cars use the larger threaded bolt pin A-Arms.  Sedan, cpe, and convert all the same arms upper and lower.

 Six cylinder car A-Arms won't fit. Smaller threaded bolt pins.

Edited by c49er (see edit history)
  • Like 1

Share this post


Link to post
Share on other sites

Thanks c49er, I thought that was the case. 

Do you have the partno for the correct control arm?

 

 

Share this post


Link to post
Share on other sites

Thanks Jack M. First I am in Norway, so pulling the arm from your car would be difficult!

Also the Windsor parts will not fit, but thanks any way!

 

 

Share this post


Link to post
Share on other sites

Dang, wont fit,  I will bet you were looking forward to the trip too.

Oh well, good luck with this.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this