RKAJFSAZ Posted February 18, 2019 Share Posted February 18, 2019 ANYONE KNOW WHAT THE RESISTANCE OF THE SERIES 12 GAS TANK SENDING UNIT SHOULD BE, NEED TO FIND SOMETHING THAT WILL WORK FOR MY NEW PROJECT THANKS, BOB K Link to comment Share on other sites More sharing options...
Mkgage Posted February 18, 2019 Share Posted February 18, 2019 K M Lifestyle has sending units for series 12. WWW;mykmlifestyle.com Link to comment Share on other sites More sharing options...
SD Franklin Service Statio Posted February 20, 2019 Share Posted February 20, 2019 Resistance for the gauge should be between the ignition switch and gauge. - Mike Link to comment Share on other sites More sharing options...
RKAJFSAZ Posted February 21, 2019 Author Share Posted February 21, 2019 I was hoping someone would know: 1- The resistance of the tank sending unit when empty 2- The resistance of the tank sending unit when full as measured on the driver side terminal block, with the two wires that go the instrument gauge disconnected (just looking for the range of the sending unit). When I dropped the tank to clean it out (a job I hate), I discovered the sending unit was missing. I have a few of the instrument gas gauges, but not sure if there any good. Im going to try and get a gauge & sending unit set up and functioning on the bench before installing in the car (the gauges were made by Nagel) Thanks Bob K Link to comment Share on other sites More sharing options...
SD Franklin Service Statio Posted February 23, 2019 Share Posted February 23, 2019 To be honest, putting a stick in the gas tank to check might be easier! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now