Jump to content

Looking for a good Reliable & reputable chrome shop


Recommended Posts

I have been very happy with Librandi's Chrome in Harrisburg PA. Lifetime warranty as long as you own the car. They stuck to the deadline even finished the job two weeks earlier then promised.  

  • Like 1
Link to post
Share on other sites

LiBrandi's is near the the Airport in Harrisburg, PA.  

I have used them many times with outstanding results and have never heard of any complains from others either in person or postings on this website.

If they are small parts you should have no problems shipping the parts.

http://www.carchrome.com

 

From what I have heard Paul's Chrome is also good.  http://www.paulschrome.com

 

Neither one is cheap, but then again you get what you pay for.

Edited by Vila (see edit history)
Link to post
Share on other sites
41 minutes ago, Vila said:

From what I have heard Paul's Chrome is also good.  http://www.paulschrome.com

 

Neither one is cheap, but then again you get what you pay for.

 

Paul's Chrome did some bumpers and other smaller parts for me a few years ago. They were not cheap but the quality of the work was top notch.

I was not in a big hurry so I took the parts to Fall Hershey. Their representative looked at them then took them back to their shop so I only had to pay for shipping back to me when the job was done. Since the OP has a few small parts then shipping both ways should not be all that expensive compared to bumpers.

Link to post
Share on other sites

Put me in for Librandi's in Harrisburg, they have been in the chrome business for at least 35 years and know what an old car owner expects.  Last time I was there the owner was showing his own 1948 Town & Country at Hershey so these are car people who know what they are doing.  No chrome is cheap so you might as well at least be confident you will not be disappointed, Todd C

Link to post
Share on other sites

I too have used Librandi's and been very happy.  Long lead time but quality work. As far as cost goes, it's best not to talk about that, a small box of parts can end up costing thousands. 

 

For pot metal work, I'd highly recommend R&D Finishing in Elizabethton, Tenn,  http://rdfinishing.net/    They'll save detail and do a great job......

Link to post
Share on other sites
On 6/20/2018 at 1:38 PM, Rob1965 said:

Reliable & Reputable

So far I tried a good shop next to me . supper happy so far . My advice try the one in your town by you and give the local guy a chance .Just look at the stuff that was just finished .

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...