Jump to content

37 pu exhaust/intake brass washers ?


Recommended Posts

They go on the exhaust manifold at each end where it bolts to the block. There should be 4 and 4 special nuts that nestle in the tapered part. The nut can be replaced with stainless cap nuts by drilling through the ends of the caps. There should be 4 thick hard washers that clamp the intake to the exhausts manifold too.

Link to post
Share on other sites

I think that those flex-locs are their substitutes for the rounded nuts used with the brass washers as the original nuts are not available ,that I know of. I would just drill out the cap nuts, use the round top nuts not pointed. I think that they are 3/8 nuts an they'll fit just fine. Be careful not to remove the threads.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...