Curt Curtiss Posted June 7, 2016 Share Posted June 7, 2016 I have the repair manual for the 8-98 but the book has very little detail on the engine assembly and torque specs. Is there a book on the Auburn 8-98, 8-105 or any of the Lycoming straight 8 engines that shows pictures and provides assembly detail and torque specs on the engine? Link to comment Share on other sites More sharing options...
Mike Dube Posted June 24, 2016 Share Posted June 24, 2016 Afraid there is not much to find in that regard. You should start looking for period 'Motors' or 'Chiltons' type general automotive manuals that overlap the period when these were still in the used car category. The earlier the better, for more info on removing, replacing & rebuilding things. Even then, not much about torque values to be found in old books. Link to comment Share on other sites More sharing options...
ron hausmann Posted July 11, 2016 Share Posted July 11, 2016 Sir, Kissel manuals might help. Kissel Kars used Lycoming blocks for their eight cylinder cars from 1925 thru 1930. Huge eight cylinder blocks also used in Duesenbergs, Cords, and Auburns. Kissel however took the big Lycoming blocks and cast their own heads. Kissel also used their own lightweight pistons, crank, and rods in order to assure absolutely perfect balance and workmanship on these high end Kissel cars. I own one of the four known Kissel 8-126 engines, shown below. Was running a sawmill in California when I got it. I have been told that it is the same engine as Auburns and Cords used, but it has the Kissel improvements above. You might want to get a Kissel Model 8-126 manual to work on your Lycoming. These show up on ebay every few months - there are more manuals I think than engines extant. Thanks, Ron Hausmann P.E. Link to comment Share on other sites More sharing options...
prewar40 Posted July 11, 2016 Share Posted July 11, 2016 (edited) There are Lycoming pamphlets at Gardner Motor Cars at the 'Tech Aids & Tips' link for the GT 226 CID, GS & GR 247 CID and MD 299 CID. Nothing there about torque. Edited July 12, 2016 by prewar40 add link to site (see edit history) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now